Sales@Lisungroup.com +8618117273997

English

中文简体

English

Русский

Español

Português

Türkçe

العربية

Deutsch

Polski

Italiano

Français

한국어

ไทย

Tiếng Việt

日本語

Home Standards IS 16104: 2012 d.c.OR a.c. Supplied Electronic Control Gear for LED Modules-Performance Requirements

IS 16104: 2012 d.c.OR a.c. Supplied Electronic Control Gear for LED Modules-Performance Requirements

This standard IS 16104: 2012 outlines the performance requirements for electronic control gear used with LED modules, in accordance with IS 16103 (Part 1): 2012, which specifies the safety requirements for LED modules used in general lighting. The control gear covered by this standard is intended for operation on both direct current (d.c.) and alternating current (a.c.) supplies, with voltages up to 1,000 V. The standard is applicable to a.c. supplies operating at 50 Hz, where the output frequency of the control gear may differ from the supply frequency.

IS 16104: d.c.OR a.c. Supplied Electronic Control Gear for LED Modules – Performance Requirements

LISUN supplies the fully test solutions for the following BIS IS 16104(Part 1): 2012 , please see the below excel table:

BS IS 16104 Clause and Subject	LISUN Model
3.1 Total Circuit Power	DC3005
3.2 Circuit Power Factor	LS2050B
5.1 Classification according to the load	M9822B
7.3 Capacitive Load Requirement	M9822B
12. Test for Reduced LED Modules Resistance	WB2681A
13.1 The control gear shall be subjected to a temperature cycling shock test	GDJS-015B
Annex A.3 Firgure 2 Measurement of impedance at audio-Frequencies	FD2810B
Annex B a guide to quoting product life and failure rate	LEDLM-80PL